EPDM Commercial Roofing in Fort Worth, TX

Yes. Ariel Roofing installs and repairs epdm roofing on commercial buildings throughout Fort Worth and Tarrant County. A lot of 1980s–90s DFW office parks are on ballasted EPDM. Where the deck and insulation are dry, those roofs are often the best coating candidates in the region rather than tear-off jobs.

20–30 years is the realistic service range when the system is installed to the manufacturer's detail and maintained. In Fort Worth, tarrant County sits in the heart of hail alley, and west-side buildings take higher sustained wind than the Dallas side of the metroplex. That exposure — not the sheet itself — is what determines whether you reach the top or the bottom of that range.

We don't quote commercial roofing by the square over the phone. Price depends on deck type, existing insulation and how wet it is, tapered drainage design, rooftop equipment, access, and phasing around your tenants. We scan and measure the roof first, then hand you a fixed-price scope you can compare line for line.

We pull the commercial re-roof permit in Fort Worth, meet the inspections, and provide the insulation and membrane documentation the energy code requires on a tear-off.

Yes. Most of our Fort Worth commercial work is phased — after-hours tear-off, weekend lifts, and section-by-section dry-in so no part of the building is ever left open overnight.

We give every owner all three numbers. An infrared scan tells us how much insulation is wet. Under roughly a quarter, restoration usually buys 10–15 years at a fraction of replacement. Above that — or with a compromised deck — replacement is the cheaper decision over five years.