– Commercial Roofing In Dallas –
Commercial Roofing Contractor in Dallas, TX
Dallas, Dallas County • Licensed & Insured
Get Started
Free Roof Inspection
— Free Roof Inspection
Tell us about your roof.
A senior estimator will call within one business day to schedule your on-site assessment — no obligation, no high-pressure sales.
Ariel Roofing is a licensed commercial roofing contractor working across Dallas — from the low-slope warehouse stock along Stemmons and the Trinity Industrial District, to Deep Ellum mixed-use rooftops, Uptown mid-rise decks, and the office and retail parks off LBJ and Central Expressway. We install and restore TPO, PVC, EPDM, modified bitumen and metal systems, and we phase the work around your tenants so the building keeps operating.
Where We Work In Dallas
- Stemmons Corridor, Trinity Industrial, Design District, Deep Ellum, Uptown, Oak Lawn, Preston Center, North Dallas along the Central and LBJ corridors, Redbird, and the Pleasant Grove industrial parks.
- Crews stage off I-35E, I-30, I-635 and US-75, which keeps most Dallas job sites within a 30-minute service window.
What's Included
- Free infrared moisture scan and drone roof report
- TPO, PVC, EPDM, mod-bit, metal retrofit and coatings
- After-hours and weekend phasing for occupied buildings
- City of Dallas permits and inspections handled
- 15–30 year manufacturer NDL warranty options
- Hail and wind claim documentation for your adjuster
Dallas Weather Is What Kills Low-Slope Roofs Here
Dallas roofs take 100°F-plus summer deck temperatures, sharp winter swings, and hail several times a season. That combination cycles membranes and fasteners until seams split and flashings pull. On single-ply we specify thicker 60–80 mil membranes with hail-rated cover board rather than the 45 mil minimum, and on mod-bit we use granulated cap sheets that survive stone impact better than smooth surfacing.
The Building Stock We See Most
Mid-century tilt-wall warehouses with gravel-surfaced built-up roofs at the end of their life, 1980s office parks on ballasted EPDM, newer distribution buildings on mechanically attached TPO, and Deep Ellum and Design District brick buildings with patched-over modified bitumen. Each one gets a different recommendation — a ballasted EPDM roof over a good deck is often a coating candidate, while a saturated gravel BUR is a full tear-off.
Permits, Code And Drainage In Dallas
Commercial re-roofs inside the city require a permit through Dallas Development Services, and any tear-off to deck triggers current energy-code insulation values. We also correct ponding while the roof is open — tapered ISO crickets behind curbs and at drains — because standing water past 48 hours voids most manufacturer warranties and is the single most common reason a Dallas flat roof fails early.
Keeping Your Tenants Open
For occupied Dallas buildings we work in sections, dry-in every night, protect the interior under rooftop units, and coordinate crane or hoist lifts for off-hours. Restaurants in Deep Ellum and Bishop Arts typically get overnight work; distribution buildings usually get weekend phases scheduled around shipping windows.
Repair, Restore, Or Replace
We give every Dallas building owner all three numbers. If the infrared scan shows under 25% wet insulation and the membrane still has elongation, a silicone restoration coating can add 10–15 years at roughly a third of replacement cost. Above that, or where the deck is compromised, we quote a tear-off and full system so you are not paying twice inside five years.
Maintenance Programs
Most Dallas commercial roofs fail at the details, not the field — pitch pans, HVAC curbs, and drain sumps. Our semi-annual program cleans drains, reseals penetrations, and delivers a photo report before and after storm season, which also keeps NDL warranty requirements intact.
Service Area
Commercial roofing service area — Dallas, TX
FAQ
Frequently Asked Questions
What commercial roof systems do you install in Dallas?
Heat-welded TPO and PVC single-ply, EPDM, two- and three-ply modified bitumen, standing-seam metal retrofits, and silicone or acrylic restoration coatings over sound existing membranes. System choice comes down to your deck, insulation R-value, rooftop equipment load, and how long you plan to hold the building.
Do you pull commercial roofing permits with the City of Dallas?
Yes. We pull commercial re-roof permits through Dallas Development Services, handle the required inspections, and provide the insulation and membrane documentation needed to satisfy the current Dallas energy code for low-slope roofs.
Can you work at night or on weekends so we stay open?
Most of our Dallas commercial work is phased around tenant operations — after-hours tear-off, weekend crane lifts, and section-by-section dry-in so no part of the building is ever left open overnight.
How fast can you respond to a leak on a Dallas flat roof?
Same-day emergency response inside Loop 12 and next-day for the rest of Dallas County. We tarp and dry the area, infrared-scan for saturated insulation, and give you a written repair-versus-replace recommendation with photos.
What warranty comes with a Dallas commercial roof?
Manufacturer NDL warranties of 15 to 30 years on qualifying single-ply and modified-bitumen systems, plus Ariel Roofing's own workmanship warranty. We are a certified installer, so the warranty is registered and inspected by the manufacturer, not just by us.
Do you handle hail claims on commercial buildings?
Yes. Dallas County averages several damaging hail events a year. We document membrane bruising, split laps, and damaged HVAC screens with a drone and infrared report your adjuster can work from, and we attend the adjuster meeting with you.